How do I locate my Radio ID? How long is my XM radio trial for? When you initially purchase you receive 3 months of XM for free. You still need to sign up to receive XM. How much is XM after the trial if I want to continue my service? Are dealers responsible for servicing my XM?
However, your XM Radio subscription service is not included with the warranty. What do I do? Your XM Radio service needs to be refreshed. Turn to channel 0 and write down the eight-digit Radio ID. How do I program my HomeLink garage door opener? Homelink is the original control system that allows you to communicate wirelessly from your vehicle to open garage doors, turn on lights, open gates and more.
It's all about making your life more convenient and safe. When you're programing HomeLink for the first time, you need to make sure that all factory-installed codes are erased from your new unit before putting it into training mode. To do that, follow these simple steps: First, turn your vehicle's ignition switch to the second position.
This is sometimes called the accessory position. Now HomeLink is in training mode and you're ready to program the system. Now, place the hand held transmitter 1 to 3 inches away from the HomeLink surface keeping the HomeLink indicator light in view. Now, you'll need to decide which HomeLink button your want to program.
Using both hands simultaneously press and hold both the desired HomeLink button and handheld transmitter button. Don't release the buttons until the HomeLink indicator light flashes slowly and then rapidly.
When the indicator light flashes rapidly, that's the sign that your programming was successful. Now both buttons may be released. In this next step, press and hold the programmed HomeLink button and observe the indicator light.
If the indicator light is solid and continuous, programming is complete and your device should activate when the HomeLink button is pressed and released.
That requires additional programming steps. To program a rolling code garage door opener make sure you have completed the previous steps, then proceed with the following actions.
You will need to access the garage door opener receiver also called the motorhead unit in your garage. Once you're there, you need to find the "learn" or "smart" button. It's usually near where the hanging antenna wire is attached to the unit. The name and color of the button may vary by manufacturer. If you have difficulty in finding the training button, reference your garage door opener manual.
Once you're found the "learn" or "smart" button, press and release it. Please note that once the button is pressed you have 30 seconds to initiate the next step. Return to the inside of the vehicle and firmly press and hold the programmed HomeLink button for 2 seconds and release.
Homelink should now activate your rolling code equipped device. For more information about programming a security system, a door lock or home lighting, go to www.